FWLF1631R17 Datasheet, PDF (6/10 Pages) Finisar Corporation. – Long-Reach DWDM SFP Transceiver

FWLF1631RXX DWDM SFP Preliminary Product Specification – November 2006
Finisar
V. Optical Parameters
Parameter
Symbol Min Typ Max Units Notes/Conditions
TRANSMITTER CHARACTERISTICS
Center Wavelength Spacing
Modulated Spectral Width
Transmitter Center Wavelength –
End of Life
Transmitter Center Wavelength –
Start of Life
Side Mode Suppression Ratio
(SMSR)
Optical Rise/Fall Time
Transmitter Optical Output Power
Transmitter Extinction Ratio
Transmitter Eye Opening
Transmitter Jitter Generation
∆λ ₂₀
λ_c
λ_c
SMSR
t_r / t_f
P_out
OMI
Tolerable Back Reflection
BR
Relative Intensity Noise
RIN
Dispersion Power Penalty at
DPP
3200ps/nm
RECEIVER CHARACTERISTICS
Optical Input Wavelength
P_in
Receiver Jitter Generation
Optical Input Power
(BER < 10 ^-12)
Optical Input Power –
Receiver Damage Threshold
Receiver Reflectance
Dispersion Noise Penalty at
3200ps/nm
P_in
R_RX
DNP
X - 100
Y - 25
30
+3
8.2
10
1520
-28
100
GHz Corresponds to
approximately 0.8 nm
0.2 0.3 nm Full width, -20dB from
max. See note 3
X X + 100 pm X = specified center
wavelength
Y Y + 25 pm Y = specified center
wavelength
dB Modulated
160 ps Unfiltered, 80% -20%
+7 dBm Average power coupled
into single mode fiber
dB
% OC-48 eye mask margin
75 mUI Parameters per GR-253²
section 5.6 for OC-48 B
-14 dB See note 4
-120 dB/Hz
3.0 dB See Note 5
1570
75
-9
+6
nm
mUI
dBm
dBm
Parameters per GR-253²
section 5.6 for OC-48 B
2.5 Gb/s w/
PRBS 2 ²³ -1
-27 dB
3.0 dB See Note 6
Notes:
1. Parameters are specified over temperature and voltage, at end of life unless otherwise noted.
2. All parameters are measured on a Finisar SFP Evaluation Card unless otherwise noted.
3. For accurate ∆λ₂₀ measurements, an OSA with a resolution band width of = 20pm is recommended.
4. Tolerable back reflection is the max back reflection level at which the power penalty will be <1dB. Power penalty is
measured over fiber (2400ps/nm) at BER = 10^-12 under high OSNR (>28dB) conditions.
5. Dispersion power penalty is measured in loop back with OSNR set to 28 dB. Data rate and pattern used same as specified
for Optical Input Power. Dispersion power penalty is the difference in Rx power at a BER of 10^-12 for 0ps/nm and
3200ps/nm.
6. Dispersion noise penalty is measured in loop back with Rx power set between -9dBm and -22dBm. Data rate and pattern
used same as specified for Optical Input Power. Dispersion noise penalty is the difference in OSNR at a BER of 10^-12 for
0ps/nm and 3200ps/nm
© Finisar Corporation
Rev B, November 2006
PRELIMINARY and Confidential
Page 6