FTL-1619-47 Datasheet, PDF (5/9 Pages) Finisar Corporation. – CWDM GBIC Transceiver with APD Receiver

FTL-1619-XX WDM GBIC
Product Specification February 2007
Finisar
V. Optical Parameters
Parameter
Transmitter
Transmitter Center Wavelength
Wavelength Temperature
Dependence
Spectral Width
Side Mode Suppression Ratio
(SMSR)
Optical Rise/Fall Time
Transmitter Optical Output Power
Transmitter Extinction Ratio
Transmitter Eye Opening
Transmitter Jitter
Dispersion Penalty at 100km
Receiver
Optical Return Loss
Optical Input Wavelength
Receiver Jitter Generation
Receiver Optical Input Power
(BER < 10^-12 w/ PRBS 2⁷-1)
Symbol Min Typ Max Units Notes/Conditions
λ_c
(x-6.5) (x+1) (x+6.5) nm Over temperature 0 to
70 °C case temperature.
See Note 1 below.
0.09
nm/°C
SMSR 30
1
nm Full Width, -20dB from
peak
dB
t_r/t_f
200 ps Unfiltered, 80% -20%
P_out
+1.0 +3.0 +5.0 dBm Average power coupled
into single mode fiber
ER
9
dB
10
% Gigabit Ethernet eye
mask margin
100 ps Peak to peak, filtered
3.0 dB See Note 4
ORL
λ_in
14
1450
1620
100
P_in
-30
-7
Table 6. Optical parameters
dB
nm
ps See Note 5.
Peak to peak
dBm @ 1.25Gb/s,
PRBS 2⁷-1 pattern
Note 1: The Transmitter Center Wavelength “x” is as specified by the customer. The current available
wavelengths are: 1470, 1490, 1510, 1530, 1550, 1570, 1590, and 1610 nm. Please see the “Product
Selection” section on page 1.
Note 2: Parameters are specified over temperature and at end of life unless otherwise noted.
Note 3: All parameters are measured on a Finisar GBIC Evaluation Card unless otherwise noted.
Note 4: SMF-28 fiber used. 100kms represents 2000ps/nm at 1610nm. Measured at 1.25Gb/s with a
PRBS 2⁷-1 pattern at a BER<10^-10.
Note 5: Jitter added by receiver.
© Finisar Corporation February 2007 – Rev. B
Page 5