FWLF16197D Datasheet, PDF (4/10 Pages) Finisar Corporation. – WDM SFP Transceiver with APD Receiver

FWLF16197Dxx SFP Product Specification May 2010
Finisar
3. Into 100 ohms differential termination.
4. 20 – 80 %
5. Loss Of Signal is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
6. Receiver sensitivity is compliant with power supply sinusoidal modulation of 20 Hz to 1.5 MHz up to
specified value applied through the recommended power supply filtering network.
IV. Optical Characteristics (T_OP = 0 to 70 °C, V_CC = 3.15 to 3.60 Volts)
Parameter
Transmitter
Output Opt. Pwr (End of Life)
Optical Wavelength
Wavelength Temperature Dependance
Spectral Width (-20dB)
Optical Extinction Ratio
Sidemode Supression ratio
Optical Rise/Fall Time
RIN
Transmitter Jitter (peak to peak)
Receiver
Average Rx Sensitivity
Maximum Input Power
Optical Center Wavelength
LOS De -Assert
LOS Assert
LOS Hysteresis
Receiver Jitter Generation (peak to peak)
Dispersion Penalty at 100km
Symbol
P_OUT
λ
σ
ER
SSR_min
t_r/ t_f
RIN
R_SENS2
P_MAX
λ_C
LOS_D
LOS_A
Min
+0
(x-4)
9
30
-7
1270
-42
Typ
(x+1)
0.08
1.0
Max
+5
(x+7)
0.125
1
180
-120
100
-29
1620
-32
160
2.5
Unit Ref.
dBm 1
nm
nm/°C
nm
dB
dB
ps 2
dB/Hz
ps
dBm 3
dBm
nm
dBm
dBm
dB
ps 4
dB 3,5
Notes :
1. Over case temperature of 0 to 70 °C. The Transmitter Center Wavelength “x” is as specified by the
customer. The current available wavelengths are: 1470, 1490, 1510, 1530, 1550, 1570, 1590, and 1610
nm. Please see the “Product Selection” section on page 1.
2. Unfiltered
3. Worst-case extinction ratio. Measured with a PRBS 2⁷-1 test pattern, @1.25Gb/s, BER<10^-12 , EOL
4. Jitter added by receiver (peak to peak). Measured at –29dBm average Rx sensitivity, PRBS 2⁷-1 test
pattern.
5. Measured using 9/125υ m SMF-28.
© Finisar Corporation May 2010 Rev.A
Page 4