FTLX6811MCC Datasheet, PDF (15/16 Pages) Finisar Corporation. – 1600 ps/nm (80km) Tunable XFP Optical Transceiver

FTLX6811MCC and FTLX6814MCC T-XFP Product Specification – July 2011
Finisar
XI. Notes & Exceptions
• XFI and Line Loopback operation:
o When XFI Loopback is enabled, the Transmitter output is disabled.
o When Line Loopback is enabled, the CDR output is disabled.
• 8.5Gb/s operation requires configuration change via I2C vendor reserved
command.
XII. References
1. 10 Gigabit Small Form Factor Pluggable Module (XFP) Multi-Source Agreement
(MSA), Rev 4.5 – August 2005. Documentation is currently available at
http://www.xfpmsa.org/
2. Application Note AN-2035: “Digital Diagnostic Monitoring Interface for XFP
Optical Transceivers” – Finisar Corporation, December 2003
3. Directive 2002/95/EC of the European Council Parliament and of the Council,
“on the restriction of the use of certain hazardous substances in electrical and
electronic equipment”. January 27, 2003.
4. “Application Note AN-2038: Finisar Implementation Of RoHS Compliant
Transceivers”, Finisar Corporation, January 21, 2005.
5. SFF-8477 Revision 1.3: “Specification for Tunable XFP for ITU Frequency Grid
Applications”. October 20^th, 2008. Documentation is currently available at
ftp://ftp.seagate.com/sff
XIII. Product Selection Details
FTLX6811MCC-xx/ FTLX6814MCC-xx
FT: FT Series
L: RoHS-6
X: 10G Bit Rate Class
68: 80km (asymmetric chirp) widely tunable with APD Receiver
1: XFP form factor
1: Gen 1 (Standard Performance), 4: Gen 1 (High-Performance)
M: Multiprotocol, 8.5Gb/s supported with I2C command
C: Commercial temperature range
C: ITU-T C-Band 50GHz spacing
xx: customer specific (not required for standard configuration)
© Finisar Corporation 2011
1117598 Rev A03
Page 15