V23826-K15-C313 Datasheet, PDF (14/19 Pages) Finisar Corporation. – Single Mode 1300 nm 1.0625 Gbit/s Fibre Channel 1.3 Gigabit Ethernet 1x9 Transceiver

V23826-K15-Cxx, V23826-K15-Cxxx Product Specification – August 2004
Single Mode 1300 nm Gigabit Ethernet/Fibre Channel 1x9 Transceiver,
AC/DC Version
Laser
Driver
100 Ω
VEETx 9
TD+ 8
1)
TD− 7
VCC SerDes
5 V / 3.3 V
1x9 Transceiver
Signal
Detect
Pre-
Amp
Limiting _RD-
Amplifier
RD+
VCCTx 6
C1
VCCRx 5
C2
SD 4
1)
RD− 3
L1
VCC
5 V / 3.3 V
L2
C3
SD to upper level
R9
RD+ 2
VEERx 1
VCC
Tx+
ECL/PECL
Driver
Tx-
Serializer/
Deserializer
Gigabit
Transceiver
Chip
RD-
RD+
Receiver
PLL etc.
C1/2/3 = 4.7 µF
C4/5 = 10 nF
L1/2 = 1 µH
R5/6 = 270 Ω (5 V)
= 150 Ω (3.3 V)
R9
= 510 Ω (5 V)
= 270 Ω (3.3 V)
Place R1/2/3/4/7/8 close to SerDes chip,
depends on SerDes chip used,
see application note of SerDes supplier.
1) Design criterion of the capacitor used is the
resonant frequency and its value must be
in the order of the nominal data rate.
Short trace lengths are mandatory.
File: 1395
Figure 6
Values of R1/2/3/4 may vary as long as proper 50 Ω termination to V_EE or 100 Ω
differential is provided. The power supply filtering is required for good EMI performance.
Use short tracks from the inductor L1/L2 to the module V_CCRx/V_CCTx. We recommend a
GND plane under the module for getting good EMI performance.
The transceiver contains an automatic shutdown circuit. Reset is only possible if the
power is turned off, and then on again. (V_CCTx switched below V_TH).
Application Board available on request.
The stud pins S1 and S2 are not connected.
© Finisar Corporation August 27, 2004 Rev. B
Page 14