|
FWLF15217D47 Datasheet, PDF (11/12 Pages) Finisar Corporation. – Multi-rate CWDM Pluggable SFP Transceiver | |||
|
◁ |
FWLF15217Dxx SFP Product Specification â December 2006
Finisar
XII. References
1. âSONET Transport Systems: Common Generic Criteriaâ, Telcordia Technologies,
GR-253-CORE, Issue 3, Sept 2000.
2. IEEE Std 802.3. IEEE Standards Department, 2000.(*)
3. âFibre Channel Draft Physical Interface Specification (FC-PI 10.0)â. American
National Standard for Information Systems.(*)
4. âOptical Interfaces for Course Wavelength Division Multiplexing Applicationsâ,
ITU-T recommendation G.695, January 2005.
5. Small Form Factor Pluggable (SFP) Transceiver Multi-Source Agreement (MSA),
September 2000. Documentation is currently available at Finisar upon request.
6. Directive 2002/95/EC of the European Council Parliament and of the Council, âon
the restriction of the use of certain hazardous substances in electrical and electronic
equipmentâ. January 27, 2003.
7. âApplication Note AN-2038: Finisar Implementation Of RoHS Compliant
Transceiversâ, Finisar Corporation, January 21, 2005.
8. âAT24C01A/02/04/08/16 2-Wire Serial CMOS E2PROMâ, Atmel Corporation.
www.Atmel.com
9. âApplication Note AN-2030: Digital Diagnostic Monitoring Interface for Optical
Transceiversâ, Finisar Corporation, April 2002.
10. âDigital Diagnostic Monitoring Interface For Optical Transceivers Rev 9.3â. SFF
Document No. SFF-8472.
(*) Neither IEEE 802.3 nor FC-PI 10.0 specifies a 1621 nm DFB single mode interface.
The FWLF15217Dxx complies with these specifications except for the following optical
parameters, which have different values: transmitter wavelength, extinction ratio, receiver
sensitivity, and transmit output power. See Section V for details.
For More Information
© Finisar Corporation December 2006 Rev.A
Page 11
|
▷ |