FTLX1341E2 Datasheet, PDF (1/10 Pages) Finisar Corporation. – RoHS-6 Compliant 10GBASE-LRM X2 Transponder

Product Specification
RoHS-6 Compliant
10GBASE-LRM X2 Transponder
FTLX1341E2
PRODUCT FEATURES
ƒ Hot pluggable X2 MSA form factor
ƒ Total power consumption: 4.0 W maximum
ƒ RoHS-6 compliant (lead-free)
ƒ Temperature range 0°C to 70°C
ƒ Transmission distance up to 220m^*
ƒ Uncooled 1310 nm directly modulated
Fabry-Perot (FP) laser
ƒ Built In Advanced Electronic Dispersion
Compensation (EDC)
ƒ SC connector, multimode fiber
ƒ Full duplex transmission mode
ƒ Digital Optics Monitoring (DOM)
ƒ Power supply: +5.0 V, +3.3 V
ƒ Adaptable Power Supply (APS: +1.2 V)
ƒ XAUI electrical interface
- 4 x 3.125 Gb/s Ethernet
ƒ Management and control via MDIO
2-wire bus
ƒ 70-pin connector
ƒ Separated signal/chassis ground
ƒ Mid Pak module variance for
front panel mounting
ƒ De-latch mechanism with low
extraction force
APPLICATIONS
ƒ IEEE 802.3aq-2006
ƒ 10 Gb/s Ethernet transmission on
legacy multimode fiber.
The Finisar FTLX1341E2 transponder incorporates Electronic Dispersion Compensation (EDC)
which provides correction for the severe modal dispersion that may occur during propagation
through links up to 220m on legacy installed FDDI multimode fiber. The EDC device
incorporates a Feed Forward Equalizer (FFE) and a Decision Feedback Equalizer (DFE). The
EDC also contains sophisticated clock recovery architecture for extracting a robust clock from
extremely distorted signals.
PRODUCT SELECTION
FTLX1341E2
* Maximum reach as defined by IEEE. Longer reach possible depending upon link implementation.
© Finisar Corporation – October 2008
Rev B
Page 1