FDB-1032-SFP Datasheet, PDF (1/5 Pages) Finisar Corporation. – FDB-1032-SFP+ Evaluation Board for SFP/SFP+/SFP28

Product Specification
FDB-1032-SFP+ Evaluation Board for SFP/SFP+/SFP28
OVERVIEW
Finisar’s FDB-1032-SFP+ Evaluation Board
is designed for testing and evaluating all
SFP, SFP+ and SFP28 transceivers as well
as SFPwire^® Active Optical Cables. This is
not a module compliance board, but it is
compatible with MSA compliant SFP, SFP+
and SFP28 transceivers.
CONTENTS
The board consists of a single SFP28 edge
connector and SFP28 cage assembly, four
50-ohm SMA female coaxial connectors
(J15-J18) for the high-speed differential
transmitter input and receiver output
signals, and test points for monitoring the
following pins:
Module RX_LOS
Module RX Rate Select 0
Module TX Rate Select 1
Module Absent
TWI (Two Wire Interface) SCL and SDA
TX Disable
TX Fault
Eval Board Ground and Vcc
Module Vcc RX and TX
Module Ground
Case Ground
The Evaluation Board has LED’s for the:
RX_LOS
RX Rate Select 0
TX Rate Select 1
Module Absent
TWI – SDA and SCL (Low)
TX Disable
TX Fault
Eval Board Power 5V
Eval Board Power 3.3V
Customized Finisar Software that is specific
to this product is available. Please contact
your local Finisar Representative for details.
The GUI needs to be installed on a
Windows^® XP or 7 Operating System (32bit
or 64bit machine) that has an available
USB port. The USB (type B) port is on the
daughter card (called a FDB-INT-USB3).
© Finisar Corporation 03FEB2016 Rev C
Page 1