8430 Datasheet, PDF (4/4 Pages) Filtran LTD – MULTILAYER Ceramic Chip Inductor

MULTILAYER
Ceramic Chip Inductor 8430 Series
ENVIRONMENTAL CHARACTERISTICS
Item
1 Bending Strength
Specification
Appearance: No damage
2 Resistance to
Soldering Heat
3 Solderability
4 Temperature Cycle
Appearance: No damage
L change: within±10%
Q change: within±20%
The electrodes shall be at least
75% covered with new solder
coating
L change: within±10%
Q change: within±20%
5 Humidity Resistance
6 Heat Life
7 Cold Resistance
Test Methods
Test device shall be soldered on the substrate
Substrate Dimension: 95x23x1.5mm
Deflection: 2.0mm
Keeping Time: 30sec
Pre-heating: 120±20 ˚C, 1min
Solder Temperature: 260±10 ˚C Immersion Time: 3±1sec
Measured after exposure in the room condition for 24hrs
Pre-heating: 120±20 ˚C, 1min
Solder Temperature: 230±10 ˚C
Immersion Time: 3±1sec
One Cycle:
One cycle/step 1: 100±5 ˚C for 30±1min
step 2: -40±3 ˚C for 30±1min
Total: 100cycles
Measured after exposure in the room condition for 24hrs
Temperature: 40±2 ˚C
Relative Humidity: 90~95%
Time: 1000hrs
Measured after exposure in the room condition for 24hrs
Temperature: 85±2 ˚C
Applied Current: Rated Current
Time: 1000hrs
Measured after exposure in the room condition for 24hrs
Temperature: -40±5 ˚C
Time: 1000hrs
Measured after exposure in the room condition for 24hrs
PACKAGING
Packaging Quanitity
Packaging
Series
8430-03
8430-02
Unit: pcs
pcs/wheel
4,000
10,000
Reel Dimensions
Unit: mm
Series
A
B
C
D
8430-03
178
60
12
1.5
8430-02
178
60
12
1.5
Emboss Plastic Tape Specifications
Unit: mm
Series
A
B
K0
W
P
F
K
8430-03 1.1 1.9 0.95 8
4
3.5 0.95
8430-02 0.65 1.15 0.6
8
2
3.5 0.6
An ISO 9001 Registered Company
229 Colonnade Road, Ottawa, Ontario, Canada K2E 7K3
Tel: [phone] Fax: [phone] www.filtran.com
Page 4 of 4