SDI-002 Datasheet, PDF (1/2 Pages) Faraday Technology – SERIAL D1 TO RGB MODULE

SDI-002
SERIAL D1 TO RGB MODULE
+ Small compact design for pcb mounting + Auto 625/525 operation
+ 8 bit RGB output
+ Fully filtered outputs
+ Separate mixed syncs
+ Reclocked SD outputs available.
+ RsGsBs (Combined sync) available.
This interface card accepts D1 serial digits and provides all the necessary filtered analogue signals required for 8-bit
monitoring on a pcb mounting module.
Input Requirements
Input
Input Impedance
Line standard
Equalisation
1 x 270 Mb/s serial NRZI
(EBU TECH3267, SMPTE RP-259M)
75 ohm terminating
625/50 or 525/60 Auto detection
Automatic up to 40 dB at 200 MHz
(Typically 300m of Belden 8281 at 270mb/s)
Output Characteristics
Output format
Output levels
Output Impedance
Resolution
Freq Response
Noise
Either RGB or RsGsBs (As requested.)
700 mV ± 1% not including syncs
75 ohms
8 bit data / 9 bit DAC
< 0.3 dB to 5.5 MHz
> 60 dB rms to 5.5 MHz
Sync Output Characteristics
Sync output amplitude
Sync amp. on RsGsBs
2V± 5% into 75 ohm
300 mV ± 10 mV into 75 ohm
Other parameters
Power
Operating Temperature
Aqueous Washable
Package
+5V ± 0.25V
- 5V ± 0.50V
0⁰C to 40⁰C
Yes
DR00167A
(500 mA max)
(50 mA max)
ORDERING CODES
SDI-002A
SDI-002B
SDI-002C
SDI-002D
Reclocked o/p’s
x
√
x
√
RGB o/p
√
√
x
x
RsGsBs o/p
x
x
√
√
© Faraday Technology. As part of continual product improvement the specifications, details and dimensions shown in this publication are subject to change without notice
FARA012d
Page 1 of 2
Dec-99(B)