PO-005 Datasheet, PDF (1/3 Pages) Faraday Technology – CONVERTER CARD

CONVERTER CARD PO-005
FIBRE OPTIC RECEIVER TO 10 BIT VIDEO
The PO-005 converter card is a stand alone solution for single channel fibre optic to 10 bit parallel
video. Using the Gennum chipset the module provides EDH insertion for SMPTE 259M compliant
signals. The module can successfully receive a serial digital signa l over a range of up to 7km. The
PO-005 compliments the PI-005 10 bit parallel video to optic fibre transmitter.
INPUT
Optical wavelength 1270nm to 1380nm
Optical input sensitivity -29dBm for BER <1x10E-12
Optical input overload -14dBm for BER <1x10E-12
OUTPUTS
Output signal
CCIR Rec. 656 10 bit parallel video
SUPPLY
Power:
Current:
5V
300mA max
EDH OPTION
Indications:
Controls:
EDH - Error detected Here
EDA - Error detected already
UES - Unknown Error status
TRS - Insert:
Bypass Mode:
(Note 1)
(Note 1)
(Note 1)
(Note 2)
(Note 2)
Note 1. These are accessible only through the serial interface SCL and SDA.
Note 2. These are available only through the I/O interface see connector for details.
CONNECTORS
Input
Output
ST multimode
48 PIN Z-PAC 4 row x 12 on 2mm pitch
INDICATORS
Carrier Detected (Green) LED
© Faraday Technology. As part of continual product improvement the specifications, details and dimensions shown in this publication are subject to change without notice
Fara230p
Page 1 of 3
Aug-05(A)