PI-005 Datasheet, PDF (1/3 Pages) Faraday Technology – 10 BIT VIDEO TO FIBRE OPTIC TRANSMITTER

INTERFACE CONVERTER CARD PI-005
10 BIT VIDEO TO FIBRE OPTIC TRANSMITTER
The PI-005 is a stand-alone solution for 10 bit parallel video to fibre optic (serial) conversion. The
module can accommodate two fibre optic outputs or one fibre optic and one SMPTE 259M compliant
electrical output. Using the Gennum chipset the PI-005 provides EDH insertion for SMPTE 259M
serial interface for composite and component standards. The PI-005 complements the PO-005 fibre to
parallel module.
INPUT
Parallel multiplexed component signals to CCIR Rec 656.
Note. To ease interfacing into equipment data is latched by the rising edge of the clock.
Data set up time:
3 ns min to positive edge of clock
Data hold time:
2.5 ns min from positive edge of clock
OUTPUT
Output options:
Optical wavelength:
Optical output power:
Fibre:
Output connectors:
Package A: Outputs 1 & 2
2 off Optical fibre
Package B: Outputs 1 & 3
1 off Optical fibre and 1 off Electrical (compliant with SMPTE 259M)
1270nm to 1380nm
14dBm max
0.275nA 62.5/125µ
ST multimode (optical); 75Ω BNC (electrical)
SUPPLY
Power:
Current:
5V
300mA max
EDH OPTION
Indications:
Controls:
EDH - Error detected Here
EDA - Error detected already
UES - Unknown Error status
Transmit/Receive Mode:
Bypass Mode:
(Note 1)
(Note 1)
(Note 1)
(Note 2)
(Note 2)
Note 1. These are accessible only through the serial interface SCL and SDA.
Note 2. These are available only through the I/O interface see connector for details.
© Faraday Technology. As part of continual product improvement the specifications, details and dimensions shown in this publication are subject to change without notice
Fara228p
Page 1 of 3
Aug-05(B)