HCPL0501R1 Datasheet, PDF (4/9 Pages) Fairchild Semiconductor – High Speed Transistor Optocouplers

Isolation Characteristics (T_A = 0°C to +70°C Unless otherwise specified.)
Symbol
Characteristics
Test Conditions
Min Typ** Max Unit
V_ISO
R_ISO
C_ISO
Input-Output Isolation Voltage
Isolation Resistance
Isolation Capacitance
(note 5, 6) (f = 60 Hz, t = 1.0 min)
2500
—
(I_I-O ≤ 2 µA)
(note 5) (V_I-O = 500 V)⁽⁹⁾
10¹¹
—
(note 5) (V_I-O = 0 , f = 1.0 MHz)⁽⁹⁾
—
0.2
—
Vac_RMS
—
_
—
pF
** All typicals at T_A = 25°C
NOTES
1 Current Transfer Ratio is designed as a ratio of output collector current, I_O, to the forward LED input current, I_F, times 100%.
2. The 4.1 kΩ load represents 1 LSTTL unit load of 0.36 mA and 6.1kΩ pull-up resistor.
3. The 1.9 kΩ load represents 1 TTL unit load of 1.6 mA and 5.6 kΩ pull-up resistor.
4. Common mode transient immunity in logic high level is the maximum tolerable (positive) dV_cm/dt on the leading edge of the common mode pulse signal V_CM, to assure that the
output will remain in a logic high state (i.e., V_O>2.0 V). Common mode transient immunity in logic low level is the maximum tolerable (negative) dV_cm/dt on the trailing edge of
the common mode pulse signal, V_CM, to assure that the output will remain in a logic low state (i.e., V_O<0.8 V).
5. Device is considered a two terminal device: Pins 1, 2, 3 and 4 are shorted together and Pins 5, 6, 7 and 8 are shorted together.
6. 2500 VAC RMS for 1 minute duration is equivalent to 3000 VAC RMS for 1 second duration.
4
HCLP0XXX Rev. 1.0.3
www.fairchildsemi.com