 English |
|
|
|
|
|
|
|
| FST16210_05 Datasheet, PDF (2/4 Pages) Fairchild Semiconductor – 20-Bit Bus Switch | |||
| |||
| ◁ |
Absolute Maximum Ratings(Note 1)
Supply Voltage (VCC)
DC Switch Voltage (VS)
DC Input Voltage (VIN) (Note 2)
DC Input Diode Current (lIK) VIN 0V
DC Output (IOUT) Sink Current
DC VCC/GND Current (ICC/IGND)
Storage Temperature Range (TSTG)
0.5V to 7.0V
0.5V to 7.0V
0.5V to 7.0V
50mA
128mA
/ 100mA
65qC to 150 qC
Recommended Operating
Conditions (Note 3)
Power Supply Operating (VCC)
Input Voltage (VIN)
Output Voltage (VOUT)
Input Rise and Fall Time (tr, tf)
Switch Control Input
4.0V to 5.5V
0V to 5.5V
0V to 5.5V
0nS/V to 5nS/V
Switch I/O
0nS/V to DC
Free Air Operating Temperature (TA) -40 qC to 85 qC
Note 1: The âAbsolute Maximum Ratingsâ are those values beyond which
the safety of the device cannot be guaranteed. The device should not be
operated at these limits. The parametric values defined in the Electrical
Characteristics tables are not guaranteed at the absolute maximum rating.
The âRecommended Operating Conditionsâ table will define the conditions
for actual device operation.
Note 2: The input and output negative voltage ratings may be exceeded if
the input and output diode current ratings are observed.
Note 3: Unused control inputs must be held high or low. They may not float.
DC Electrical Characteristics
Symbol
Parameter
VCC
(V)
TA 40 qC to 85 qC
Min
Typ
Max
Units
(Note 4)
Conditions
VIK
Clamp Diode Voltage
4.5
1.2
V
IIN 18mA
VIH
HIGH Level Input Voltage
4.0â5.5
2.0
V
VIL
II
IOZ
RON
ICC
' ICC
LOW Level Input Voltage
Input Leakage Current
OFF-STATE Leakage Current
Switch On Resistance
(Note 5)
Quiescent Supply Current
Increase in ICC per Input
4.0â5.5
5.5
0
5.5
4.5
4.5
4.5
4.0
5.5
5.5
0.8
V
r1.0
PA 0d VIN d5.5V
10
PA VIN 5.5V
r1.0
PA 0 dA, B dVCC
4
7
:
VIN 0V, IIN 64mA
4
7
:
VIN 0V, IIN 30mA
8
12
:
VIN 2.4V, IIN 15mA
11
20
:
VIN 2.4V, IIN 15mA
3
PA VIN VCC or GND, IOUT 0
2.5
mA One input at 3.4V
Note 4: Typical values are at VCC 5.0V and TA 25qC
Other inputs at VCC or GND
Note 5: Measured by the voltage drop between A and B pins at the indicated current through the switch. On Resistance is determined by the lower of the
voltages on the two (A or B) pins.
www.fairchildsemi.com
2
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese