FPF2140 Datasheet, PDF (1/13 Pages) Fairchild Semiconductor – Full Function Load Switch with Reverse Current Blocking

October 2007
FPF2140/42/43/44/46/47
tm
Full Function Load Switch with Reverse Current Blocking
Features
„ 1.8 to 5.5V Input Voltage Range
„ Controlled Turn-On
„ 200mA and 400mA Current Limit Options
„ Undervoltage Lockout
„ Thermal Shutdown
„ <2µA Shutdown Current
„ Auto Restart
„ Fast Current limit Response Time
„ 5µs to Moderate Over Currents
„ 30ns to Hard Shorts
„ Fault Blanking
„ Reverse Current Blocking
„ Power Good Function
„ RoHS Compliant
Applications
„ PDAs
„ Cell Phones
„ GPS Devices
„ MP3 Players
„ Digital Cameras
„ Peripheral Ports
„ Hot Swap Supplies
General Description
The FPF2140/42/43/44/46/47 is a series of load switches which
provides full protection to systems and loads which may
encounter large current conditions. These devices contain a
0.12Ω current-limited P-channel MOSFET which can operate
over an input voltage range of 1.8-5.5V. Internally, current is
prevented from flowing when the MOSFET is off and the output
voltage is higher than the input voltage. Switch control is by a
logic input (ON) capable of interfacing directly with low voltage
control signals. Each part contains thermal shutdown protection
which shuts off the switch to prevent damage to the part when a
continuous over-current condition causes excessive heating.
When the switch current reaches the current limit, the part
operates in a constant-current mode to prohibit excessive
currents from causing damage. For the FPF2140/42/44/46, if
the constant current condition still persists after 30ms, the part
will shut off the switch and pull the fault signal pin (FLAGB) low.
The FPF2140/44 have an auto-restart feature which will turn the
switch on again after 450ms if the ON pin is still active. The
FPF2142/46 do not have this auto-restart feature so the switch
will remain off until the ON pin is cycled. For the FPF2143/47, a
current limit condition will immediately pull the fault signal pin
low and the part will remain in the constant-current mode until
the switch current falls below the current limit. The minimum
current limit is 200mA for the FPF2140/42/43 while that for the
FPF2144/46/47 is 400mA.
These parts are available in a space-saving 6 pin 2X2 MLP
package.
BOTTOM
Ordering Information
Part
FPF2140
FPF2142
FPF2143
FPF2144
FPF2146
FPF2147
Current Limit
[mA]
200/300/400
200/300/400
200/300/400
400/600/800
400/600/800
400/600/800
Pin 1
Current Limit
Blanking Time
[ms]
15/30/60
15/30/60
0
15/30/60
15/30/60
0
TOP
Auto-Restart
Time
[ms]
225/450/900
NA
NA
225/450/900
NA
NA
©2007 Fairchild Semiconductor Corporation
1
FPF2140/42/43/44/46/47 Rev. D
ON Pin
Activity
Active HI
Active HI
Active HI
Active HI
Active HI
Active HI
www.fairchildsemi.com