|
FPF2000_07 Datasheet, PDF (1/12 Pages) Fairchild Semiconductor – IntelliMAX™ Advanced Load Management Products | |||
|
May 2007
FPF2000-FPF2007
tm
IntelliMAX⢠Advanced Load Management Products
Features
 1.8 to 5.5V Input Voltage Range
 Controlled Turn-On
 50mA and 100mA Current Limit Options
 Undervoltage Lockout
 Thermal Shutdown
 <1µA Shutdown Current
 Auto restart
 Fast Current limit Response Time
 3µs to Moderate Over Currents
 20ns to Hard Shorts
 Fault Blanking
 RoHS Compliant
Applications
 PDAs
 Cell Phones
 GPS Devices
 MP3 Players
 Digital Cameras
 Peripheral Ports
 Hot Swap Supplies
General Description
The FPF2000 through FPF2007 is a family of load switches which
provide full protection to systems and loads which may encounter
large current conditions. These devices contain a 0.7⦠current-
limited P-channel MOSFET which can operate over an input
voltage range of 1.8-5.5V. Switch control is by a logic input (ON)
capable of interfacing directly with low voltage control signals. Each
part contains thermal shutdown protection which shuts off the
switch to prevent damage to the part when a continuous over-
current condition causes excessive heating.
When the switch current reaches the current limit, the part
operates in a constant current mode to prohibit excessive currents
from causing damage. For the FPF2000-FPF2002 and FPF2004-
FPF2006, if the constant current condition still persists after 10ms,
these parts will shut off the switch and pull the fault signal pin
(FLAGB) low. The FPF2000, FPF2001, FPF2004 and FPF2005,
have an auto-restart feature which will turn the switch on again
after 80ms if the ON pin is still active. The FPF2002 and FPF2006
do not have this auto-restart feature so the switch will remain off
until the ON pin is cycled. For the FPF2003 and FPF2007, a
current limit condition will immediately pull the fault signal pin low
and the part will remain in the constant-current mode until the
switch current falls below the current limit. For the FPF2000
through FPF2003, the minimum current limit is 50mA while that for
the FPF2004 through FPF2007 is 100mA.
These parts are available in a space-saving 5 pin SC-70 package.
Ordering Information
Part
Current Limit
[mA]
FPF2000
50
FPF2001
50
FPF2002
50
FPF2003
50
FPF2004
100
FPF2005
100
FPF2006
100
FPF2007
100
Current Limit
Blanking Time
[ms]
10
10
10
0
10
10
10
0
Auto-Restart
Time
[ms]
80
80
NA
NA
80
80
NA
NA
ON Pin
Activity
Active HI
Active LO
Active HI
Active HI
Active HI
Active LO
Active HI
Active HI
Top Mark
200
201
202
203
204
205
206
207
©2007 Fairchild Semiconductor Corporation
1
FPF2000-FPF2007 Rev. E
www.fairchildsemi.com
|
▷ |