FPF2000_05 Datasheet, PDF (1/12 Pages) Fairchild Semiconductor – IntelliMAX™ Advanced Load Management Products

May 2005
FPF2000-FPF2007
IntelliMAX™ Advanced Load Management Products
Features
1.8 to 5.5V Input Voltage Range
Controlled Turn-On
50mA and 100mA Current Limit Options
Undervoltage Lockout
Thermal Shutdown
<1uA Shutdown Current
Auto restart
Fast Current limit Response Time
3us to Moderate Over Currents
20ns to Hard Shorts
Fault Blanking
Applications
PDAs
Cell Phones
GPS Devices
MP3 Players
Digital Cameras
Peripheral Ports
Hot Swap Supplies
Typical Application Circuit
General Description
The FPF2000 through FPF2007 is a family of load switches which
provide full protection to systems and loads which may encounter
large current conditions. These devices contain a 0.7Ω
current-limited P-channel MOSFET which can operate over an
input voltage range of 1.8-5.5V. Switch control is by a logic input
(ON) capable of interfacing directly with low voltage control signals.
Each part contains thermal shutdown protection which shuts off the
switch to prevent damage to the part when a continuous
over-current condition causes excessive heating.
When the switch current reaches the current limit, the part
operates in a constant current mode to prohibit excessive currents
from causing damage. For the FPF2000-FPF2002 and
FPF2004-FPF2006, if the constant current condition still persists
after 10ms, these parts will shut off the switch and pull the fault
signal pin (FLAGB) low. The FPF2000, FPF2001, FPF2004 and
FPF2005, have an auto-restart feature which will turn the switch on
again after 80ms if the ON pin is still active. The FPF2002 and
FPF2006 do not have this auto-restart feature so the switch will
remain off until the ON pin is cycled. For the FPF2003 and
FPF2007, a current limit condition will immediately pull the fault
signal pin low and the part will remain in the constant-current mode
until the switch current falls below the current limit. For the
FPF2000 through FPF2003, the minimum current limit is 50mA
while that for the FPF2004 through FPF2007 is 100mA.
These parts are available in a space-saving 5 pin SC-70 package.
OFF ON
V_IN
V_OUT
FPF2000 - FPF2007
ON
FLAGB
GND
TO LOAD
©2005 Fairchild Semiconductor Corporation
1
FPF2000-FPF2007 Rev. D
www.fairchildsemi.com