407445 Datasheet, PDF (4/8 Pages) Extech Instruments Corporation. – Heavy Duty Hygro-Thermometer

Meter Operation
Getting Started
1. Plug the sensor into the sensor jack at the top of the meter.
2. Press the Power OFF/ON key to turn the instrument on or off.
3. Select the temperature units by pressing the °C/°F key. The display will indicate "°C"
or "°F" as selected.
4. The meter will now display the per cent relative humidity and the temperature.
NOTE: For accurate relative humidity measurements the meter should be allowed
several minutes to adjust to ambient temperature changes.
Data Hold
Press the Data Hold key to freeze the displayed temperature and humidity readings. The
HOLD icon will appear on the display in the Data Hold mode. Press the Data Hold key
again to exit the Data Hold mode.
MAX, MIN, and AVG Record / Recall
1. Press the RECORD key to begin. The REC indicator will appear on the display and the
meter will begin tracking the highest (MAX), lowest (MIN), and average (AVG)
readings.
2. Press the RECALL key to display the highest (MAX) reading. The MAX indicator along
with the maximum reading recorded since RECORD was first pressed will appear.
3. Press the RECALL key again to view the lowest (MIN) reading.
4. Press the RECALL key again to view the average reading (AVG).
5. To exit, press the RECORD key.
Measurement Considerations
1. The meter includes an Auto Power OFF feature that turns the instrument off after
approximately 10 minutes of inactivity. To disable this feature, press the RECORD key
to enable the MIN/MAX/AVG function.
2. It may be necessary to adjust the display contrast due to a change in viewing angle or
voltage drift. Use the LCD contrast adjustment located on the right side of the meter.
Page 4
Model 407445 Version 2.2 February 2004