CT20 Datasheet, PDF (1/1 Pages) Extech Instruments Corporation. – Continuity Tester Pro

Continuity Tester Pro
One person operation
For wire and cable testing; both local and remote
Features:
• A bright flashing LED and loud pulsating beeper indicate
local continuity
• Remote continuity – with the use of the remote probe,
it does not tie-up two people when identifying and labeling
long distance wire/cable runs
• Flashing remote probe - Two lead, bi-color (red/green) LED
probe allows a single user to identify up to three wires or
cables at a time for correct labeling with only one trip to
the other end location - cuts down on multiple trips back
and forth
• Polarity verification - Drives a 20mA DC current pulse
through the wires or cables under test to the bi-color
remote probe; This enables the technician to identify each
of the wires under test at the other end of the cable run and
eliminates the possibility of false high impedance readings
• Lightweight/Pocketsize - clips on and hangs from the
cable(s) under test without falling off
• Dims: 3.6x2.2x1.14" (90x57x29mm); Wt: 9.2oz (260g)
• Complete with remote probe, test leads with alligator clips,
9V battery and pouch
Patented
Continuity Tester includes Remote probe with bi-color LED for wire identification highlight
Use for local continuity or for remote
wiring identification.
RED LED means wiring is reversed.
GREEN LED means wiring is
properly identified.
Ordering Information:
CT20 ............Continuity Tester Pro
www.extech.com
Specifications subject to change without notice.
2/24/11 - R1
Copyright © 2007-2011 Extech Instruments Corporation. All rights reserved including the right of reproduction in whole or in part in any form.