XRD5408 Datasheet, PDF (9/16 Pages) Exar Corporation – 5V, Low Power, Voltage Output Serial 8/10/12-Bit DAC Family

XRD5408/10/12
DAC
n
SDIN
Figure 6. Shift Register Format
MSB X X X X
DOUT
The DACs are programmed by a 16 bit word of serial data.
The format of the serial input register is shown in Figure 6.
The leading 4 bits are not used to update the DAC. If the
DAC is not daisy-chained then only a 12 bit serial word is
needed to program the DAC. The next 8, 10 or 12 bits
after the 4 leading bits are data bits. The XRD5408’s first
8 bits are valid data and the trailing 4 bits must be set to 0.
Figure 7 demonstrates the 16 bit digital word for the 8,
10,12 bit DACs.
Part
XRD5412
XRD5410
XRD5408
Leading
Unused
Bits
XXXX
XXXX
XXXX
Data Bits
MSB
LSB
XXXXXXXX
XXXXXXXX
XXXXXXXX
Trailing
“0”
Bits
None
00
0000
Table 2. 16-Bit Digital Word Register for XRD5408,
XRD5410, XRD5412.
AC_FT Feedthrough (DAC Code = 0)
AC Feedthrough from V_REFIN to V_OUT is minimized with
low impedance grounding as shown in Figure 7. If the
DAC data is set to all “0”s then V_OUT is a function of the
divider between the DAC string impedance and ground
impedance. See the Power Supply and Grounding
section for recommendations. The typical AC
feedthrough for a 1kHz 2Vpp signal with code = 0 is
-80dB.
V_REFIN
R_IN
XRD5408/10/12
--
V_OUT
+
SCLK should be held low when CS transitions low. Data is
clocked in on the rising edge of SCLK when CS is low.
SDIN data is held in a 16 bit serial shift register. The DAC
is updated with the data bits on the rising edge of CS.
When CS is high data is not shifted into the
XRD5408/10/12.
Daisy-Chaining
The digital output port (DOUT) has a 4mA drive for greater
fan-out capability when daisy-chaining. DOUT allows
cascading of multiple DACs with the same serial data
stream. The data at SDIN appears at DOUT after 16 clock
cycles plus one clock width (t_CH) and a propagation delay
(t_DO). DOUT remains in the state of the last data bit when
CS is high. DOUT changes on the falling edge of SCLK
when CS is low.
Any number of DACs can be connected in this way by
connecting DOUT of one DAC to SDIN of the next DAC.
GND
RGND
Analog GND
Figure 7. AC_FT Feedthrough Equivalent
Circuit, DAC Code =0
Compatible with MAX515 & MAX539
The XRD5408/10/12 family of DACs are functionally
campatible with the MAX515 & MAX539 while providing
significant improvements. The XRD5408/10/12 DACs
have lower power, faster serial ports, and a constant
reference impedance to minimize the reference driving
requirements and maximize system linearity. The DOUT
Rev. 1.20
9