XRT73LC04A Datasheet, PDF (8/64 Pages) Exar Corporation – 4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT

XRT73LC04A
4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
REV. 1.0.1
PIN DESCRIPTIONS (BY FUNCTION)
TRANSMIT INTERFACE
PIN #
34
25
3
12
32
23
5
14
42
30
139
7
NAME
TTIP_0
TTIP_1
TTIP_2
TTIP_3
TRing_0
TRing_1
TRing_2
TRing_3
TxClk_0
TxClk_1
TxClk_2
TxClk_3
41
TPData_0
29
TPData_1
140
TPData_2
8
TPData_3
40
TNData_0
28
TNData_1
141
TNData_2
9
TNData_3
TYPE
O
O
I
I
I
DESCRIPTION
Transmit TTIP Output - Channel (n):
The XRT73LC04A uses this pin along with TRing_(n) to transmit a bipo-
lar line signal via a 1:1 transformer.
Transmit Ring Output - Channel (n):
The XRT73LC04A uses this pin along with TTIP_(n) to transmit a bipolar
line signal via a 1:1 transformer.
Transmit Clock Input for TPData and TNData - Channel (n):
This input pin must be driven at 34.368 MHz (for E3 applications),
44.736 MHz (for DS3 applications), or 51.84 MHz (for SONET STS-1
applications). The XRT73LC04A uses this signal to sample the
TPData_(n) and TNData_(n) input pins. By default, the XRT73LC04A is
configured to sample these two pins on the falling edge of this signal.
NOTE: If the XRT73LC04A is operating in the HOST Mode, then the
device can be configured to sample the TPData_(n) and TNData_(n)
input pins on either the rising or falling edge of TxClk_(n).
Transmit Positive Data Input - Channel (n):
The XRT73LC04A samples this pin on the falling edge of TxClk_(n). If
the device samples a "1", then it generates and transmits a positive
polarity pulse to the line.
The data should be applied to this input pin if the Transmit Section is
configured to accept Single-Rail data from the Terminal Equipment.
NOTE: If the XRT73LC04A is operating in the HOST Mode, then the
XRT73LC04A can be configured to sample the TPData_(n) pin on either
the rising or falling edge of TxClk_(n).
Transmit Negative Data Input - Channel (n):
The XRT73LC04A samples this pin on the falling edge of TxClk_(n). If
the device samples a "1", then it generates and transmits a negative
polarity pulse to the line.
In Single-Rail Mode, this pin must be tied to GND to enable the HDB3/
B3ZS Encoder and Decoder, (internally pulled-down).
In Dual-Rail Mode this input is the N-Rail Data input.
NOTE: If the XRT73LC04A is operating in the HOST Mode, then the
XRT73LC04A can be configured to sample the TNData_(n) pin on either
the rising or falling edge of TxClk_(n).
4