XRT75L03 Datasheet, PDF (65/92 Pages) Exar Corporation – THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR

THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
XRT75L03
REV. 1.0.4
TABLE 20: BLOCK LEVEL INTERRUPT STATUS REGISTER - CR33 (ADDRESS LOCATION = 0X21)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
Reserved
Channel 2
Channel 1
Channel 0
Interrupt Status Interrupt Status Interrupt Status
R/O
R/O
R/O
R/O
R/O
R/O
R/O
R/O
0
0
0
0
0
0
0
0
BIT NUMBER NAME
7-3
2
Unused
Channel
2 Inter-
rupt Sta-
tus
TYPE
R/O
R/O
DEFAULT
VALUE
DESCRIPTION
0
0
Channel 2 Interrupt Status Bit:
This READ-ONLY bit-field indicates whether or not the XRT75L03
has a pending Channel 2-related interrupt that is awaiting service.
0 - Indicates that there is NO Channel 2-related Interrupt awaiting
service.
1 - Indicates that there is at least one Channel 2-related Interrupt
awaiting service. In this case, the user’s Interrupt Service routine
should be written such that the Microprocessor will now proceed to
read out the contents of the Source Level Interrupt Status Register -
Channel 2 (Address Location = 0x12) in order to determine the
exact cause of the interrupt request.
NOTE: Once this bit-field is set to "1", it will not be cleared back to
"0" until the user has read out the contents of the Source-
Level Interrupt Status Register bit, that corresponds with
the interrupt request.
62