SP26LV432 Datasheet, PDF (4/20 Pages) Sipex Corporation – High Speed, Low Power Quad RS-422 Differential Line Receiver

SP26LV432
HIGH SPEED +3.3V QUAD RS-422 DIFFERENTIAL LINE RECEIVER
REV. 1.0.0
ABSOLUTE MAXIMUM RATINGS
These are stress ratings only and functional operation of the device at these ratings or any other above those indicated in the operation sections to the
specifications below is not implied. Exposure to absolute maximum rating conditions for extended periods of time may affect reliability and cause permanent
damage to the device.
V_CC (Supply Voltage)
V_CM (Common Mode Range)
V_DIFF (Differential Input Voltage)
V_IN (Enable Input Voltage)
T_STG (Storage Temperature Range)
I_O (Maximum Current Per Output)
Storage Temperature Range
7.0V
±14V
±14V
Vcc + 1.5V
-65°C to +150°C
±25mA
-65°C to + 150°C
Power Dissipation 16-pin PDIP
(derate 14.3mW/°C above +70°C)
1150mW
Power Dissipation 16-pin NSOIC
(derate 8.95mW/°C above +70°C)
725mW
CAUTION:
ESD (Electrostatic Discharge) sensitive device. Permanent damage may occur on unconnected devices subject to high energy electrostatic fields. Unused
devices must be stored in conductive foam or shunts. Personnel should be properly grounded prior to handling this device. The protective foam should be
discharged to the destination socket before devices are removed.
ELECTRICAL CHARACTERISTICS
UNLESS OTHERWISE NOTED: THE FOLLOWING SPECIFICATIONS APPLY FOR VCC = +3.0V TO +3.6V WITH TA =
+25^OC AND ALL MIN AND MAX LIMITS APPLY ACROSS THE RECOMMENDED OPERATING TEMPERATURE RANGE.
SYMBOL
PARAMETERS
V_CC
Supply Voltage
Enable Input Rise or Fall Times
Input Electrical Characteristics
V_TH
Minimum Differential Input Voltage
R_IN
Input Resistance
I_IN
I_IN
V_IH(EN)
V_IL(EN)
I_EN
Input Current
Input Current
Minimum Enable HIGH Input Level
Voltage
Maximum Enable LOW Input Level
Voltage
Maximum Enable Input Current
MIN.
3.0
TYP.
3
MAX. UNITS
3.6
V
ns
CONDITIONS
-200
5.0
2.0
50 +200
+1.25 +1.5
-1.5V -2.5V
mV V_OUT = V_OH or V_OL,
-7V < V_CM < +7V
kΩ V_IN = -7V, +7V, +10V
Other input = GND
mA V_IN = +10V, Other input = GND
mA V_IN = -10V, Other input = GND
V
0.8
V
±1.0
µA ^VIN ^{= V}CC ^{or GND}
V_HYST
I_CC
Input Hysteresis
Quiescent Supply Current
60
mV V_CM = 0V
5
15
mA V_CC = +3.3V, V_DIFF = +1V
4