XRD98L62 Datasheet, PDF (32/37 Pages) Exar Corporation – CCD Image Digitizers with CDS, PGA and 12-Bit A/D

XRD98L62
Preliminary
Active Video
Pixels
CCD
Signal
CAL
Internal
DC restore time
Internal Black Level
calibration time
CLAMP
(vertical shift)
End of Line N
OB pixels
Vertical Shift
Start of Line N+1
Dummy &
OB pixels
Active Video pixels
Minimum 5 Pixels
t_CAL
4 pixels
t_CAL - 4 pixels
Disconnect CDS from
input pins
Figure 22. Line Rate Timing with OneShot=1 & VSreject=1
Setting Power and Performance with Rext
The power and performance levels of the XRD98L62
are set by the value of Rext. Rext sets the current bias
level for the entire chip. Rext is connected between
pin 39 (ExtRef) and analog ground (see Figure 23).
This resistor should be placed as close as possible to
the pin and routed directly to a ground plane in a PCB
layout. A surface mount carbon resistor is recom-
mended.
Increasing values of Rext decrease the power, linearity
and noise performance of the XRD98L62. Lowering the
value of Rext increases linearity and noise perfor-
mance while increasing power. The tested default
value for Rext is 20KOhms.
In order to match system to system performance and
set consistent manufacturable performance levels
between cameras, it is recommended that the Rext
resistor have <1% tolerance.
Rev. P2.00
32