XR16M554IV80-0A Datasheet, PDF (28/46 Pages) Exar Corporation – 1.62V TO 3.63V QUAD UART WITH 16-BYTE FIFO

XR16M554/554D
1.62V TO 3.63V QUAD UART WITH 16-BYTE FIFO
REV. 1.0.0
MSR[4]: CTS Input Status
A HIGH on the CTS# pin will stop UART transmitter as soon as the current character has finished
transmission, and a LOW will resume data transmission. Normally MSR bit-4 bit is the compliment of the CTS#
input. However in the loopback mode, this bit is equivalent to the RTS# bit in the MCR register. The CTS# input
may be used as a general purpose input when the modem interface is not used.
MSR[5]: DSR Input Status
Normally this bit is the complement of the DSR# input. In the loopback mode, this bit is equivalent to the DTR#
bit in the MCR register. The DSR# input may be used as a general purpose input when the modem interface is
not used.
MSR[6]: RI Input Status
Normally this bit is the complement of the RI# input. In the loopback mode this bit is equivalent to bit-2 in the
MCR register. The RI# input may be used as a general purpose input when the modem interface is not used.
MSR[7]: CD Input Status
Normally this bit is the complement of the CD# input. In the loopback mode this bit is equivalent to bit-3 in the
MCR register. The CD# input may be used as a general purpose input when the modem interface is not used.
4.10 Scratch Pad Register (SPR) - Read/Write
This is a 8-bit general purpose register for the user to store temporary data.
4.11 Baud Rate Generator Registers (DLL and DLM) - Read/Write
These registers make-up the value of the baud rate divisor. The concatenation of the contents of DLM and DLL
gives the 16-bit divisor value. See ”Section 2.8, Programmable Baud Rate Generator” on page 13.
28