|
SP1490E Datasheet, PDF (2/8 Pages) Sipex Corporation – Full Duplex RS-485 Transceivers | |||
|
◁ |
ABSOLUTE MAXIMUM RATINGS
These are stress ratings only and functional operation of the device at
these ratings or any other above those indicated in the operation sections
of the specifications below is not implied. Exposure to absolute maximum
rating conditions for extended periods of time may affect reliability.
VCC...................................................................................................+7V
Input Voltages
Drivers................................................-0.5V to (VCC+0.5V)
Receivers..................................................................±14V
Output Voltages
Drivers......................................................................±14V
Receivers...........................................-0.5V to (VCC+0.5V)
Storage Temperature....................................................-65ËC to +150Ë
Power Dissipation.....................................................................1000mW
ELECTRICAL CHARACTERISTICS
TMIN to TMAX and VCC = 5V ± 5% unless otherwise noted.
PARAMETERS
MIN. TYP.
MAX. UNITS CONDITIONS
SP1490E/1491E driver
DC Characteristics
Differential Output Voltage
3.5
VCC Volts
Differential Output Voltage
2
VCC Volts
Unloaded; R = â ; see figure 1
With Load; R = 50â¦; (RS422);
see figure 1
Differential Output Voltage
figure 1
1.5
VCC Volts With Load; R = 27â¦; (RS485); see
Change in Magnitude of Driver
Differential Output Voltage for
Complimentary States
0.2 Volts R = 27⦠or R = 50â¦; see figure 1
Driver Common-Mode
Output Voltage
3 Volts R = 27⦠or R = 50â¦; see figure 1
Input High Voltage
2.0 Volts Applies to D
Input Low Voltage
0.8 Volts Applies to D
Input Current
±10 μA
Applies to D
Driver Short-Circuit Current
VOUT = HIGH
VOUT = LOW
±250 mA â7V ⤠VO ⤠+12V
±250 mA â7V ⤠VO ⤠+12V
SP1490E/1491E driver
AC Characteristics
Maximum Data Rate
20 Mbps
Driver Input to Output
30
40 ns
Driver Input to Output
30
40 ns
Driver Skew
5 ns
Driver Rise or Fall Time
8
20
ns
SP1491E only
Driver Enable to Output High
20
70 ns
Driver Enable to Output Low
40
70 ns
Driver Disable Time from Low
40
70 ns
Driver Disable Time from High
40
70 ns
tR/F; RDIFF = 54â¦, CL1 = CL2 = 100pF;
see figures 3 and 6
tR/F; RDIFF = 54â¦, CL1 = CL2 = 100pF;
see figures 3 and 6
see figures 3 and 6,
tR/F = | tPLH - tPHL |
From 10% to 90%; RDIFF = 54â¦,
CL1 = CL2 = 100pF; see figures 3 and 6
tR/F
CL1 = CL2 = 100pF; see figures
4 and 7; S2 closed
CL1 = CL2 = 100pF; see figures
4 and 7; S1 closed
CL1 = CL2 = 100pF; see figures
4 and 7; S1 closed
CL1 = CL2 = 100pF; see figures
4 and 7; S2 closed
Exar Corporation 48720 Kato Road, Fremont CA, 94538 ⢠510-668-7017 ⢠www.exar.com
2
SP1490_SP1491E_100_061209
|
▷ |