SPX1582 Datasheet, PDF (1/7 Pages) Sipex Corporation – 3A Ultra Low Dropout Voltage Regulator Fast Response, Adjustable & Fixed

SPX1582
3A Ultra Low Dropout Voltage Regulator
Fast Response, Adjustable & Fixed
FEATURES
■ Low Dropout Voltage 500mV at 3A Full Load Current
■ Adjustable Ouput Down to 1.25V from ATX Power Supply
■ Fixed Output Voltages of 3.3V and 2.5V
■ Extremely Tight Load and Line Regulation
■ Standard 5-Terminal Low Cost TO-220 and TO-263
SPX1582
5 Pin TO-263
1 2345
SPX1582
5 Pin TO-220
123 45
APPLICATIONS
■ 3.3V to 2.8V ATX Power Supplies
■ 3.3V to 2.9V for Portable PENTIUM^TM Processor
■ 5V to 3.5V VRE Supply
■ High efficiency "Green" Computer Systems
Now Available in Lead Free Packaging
DESCRIPTION
The SPX1582 is a 3A Low Dropout Regulator with extremely low dropout voltage. The adjustable version requires only
two external resistors to set the output voltage. The fixed version has a preset output of 3.3V, 2.8V or 2.5V and does
not require any external resistors. The SPX1582 features a low dropout of 400mV(Typ.) and offers fast transient
response. This device is suitable for Pentium applications requiring 2.8V, 2.5V from 3.3V ATX power supplies, where
low current input voltage 1V greater than the output voltage is needed. With an external sense pin the load regulation
is less than 1mV. This device is an excellent choice for the use in powering low voltage microprocessors that require
a lower dropout, fast transient response to regulate from 3.3V and 5V supplies. The SPX1582 is also an excellent choice
as a post regulator for switching supply applications.
The SPX1582 offers protection against over-current faults, reversed input polarity, over temperature operation and
positive or negative transient voltages.
The SPX1582 is offered in a 5 pin TO-220 and TO-263 compatible with industry standard 5-terminal regulators. For
5A, 3A and 1.5A ultra low dropout versions refer to SPX1581, SPX1582 and SPX1583 data sheets respectively.
TYPICAL APPLICATIONS CIRCUIT
3.3V
VIN
5V
VCTRL
VIN
5
3
C1
SPX1582
330μF
4
1
VCTRL
2
ADJ
C2
10μF
VOUT
SENSE
C3
.033μF
R1
124Ω
R2
124Ω
2.5V
VOUT
C4
2x330μF
3.3V
VIN
5V
VCTRL
VIN ₅
3 ^VOUT
C1
SPX1582
330μF
4
1
VCTRL
2
SENSE
C2
10μF
GND
2.5V
VOUT
C4
2x330μF
(1) VCTRL needed when VIN < 5V.
(2) VOUT = VREF (1+R2/R1)+IADJ R2.
(3) VREF is measured across adjust to sense.
(1) VCTRL needed when VIN < 5V.
Adjustable Regulator
Typical Fixed Regulator
Jun 17-06 Rev F
SPX1582 3A Ultra Low Dropout Voltage Regulator
1
© 2006 Sipex Corporation