ALS-PDIC17-77C-TR8 Datasheet, PDF (9/12 Pages) Everlight Electronics Co., Ltd – Ambient Light Sensor

Surface - Mount
Ambient Light Sensor
ALS-PDIC17-77C/TR8
Soldering Iron
℃ Each terminal is to go to the tip of soldering iron temperature less than 350 for 3 seconds within once
in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering
of each terminal. Be careful because the damage of the product is often started at the time of the hand
solder.
Repairing
Repair should not be done after the device have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand
whether the characteristics of the device will or will not be damaged by repairing.
Everlight Electronics Co., Ltd.
Document No: DLS-0000025 Rev4
9
http://www.everlight.com
Jun. 20, 2011