95-21SURC_13 Datasheet, PDF (9/9 Pages) Everlight Electronics Co., Ltd – Technical Data Sheet 1.9mm Round Subminiature Z-bend Lead (Square Base)LED

EVERLIGHT ELECTRONICS CO.,LTD.
4.Soldering Iron
95-21SURC/S530-A3/TR9
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and
do soldering of each terminal. Be careful because the damage of the product is often started at the time
of the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is
unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed
beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: [phone]
Fax: [phone]
http://www.everlight.com
Everlight Electronics Co., Ltd.
Device No.: SZDLE-XXX
http://www.everlight.com
Prepared date: 9-Apr-2009
Rev.2
Page: 9 of 9
Prepared by: Huang yongxin