Y7C3-AQSB Datasheet, PDF (8/10 Pages) Everlight Electronics Co., Ltd – Technical Data Sheet

Technical Data Sheet
7383/Y7C3-AQSB/X/MS
Recommended soldering conditions:
Hand Soldering
300℃ Max. (30W
Temp. at tip of iron
Max.)
Soldering time
3 sec Max.
Distance
3mm Min.(From
solder joint to
epoxy bulb)
DIP Soldering
Preheat temp.
100℃ Max. (60 sec
Max.)
Bath temp. & time 260 Max., 5 sec Max
Distance
3mm Min. (From
solder joint to epoxy
bulb)
Recommended soldering profile
laminar wave
Fluxing
Prehead
Avoiding applying any stress to the lead frame while the LEDs are at high temperature
particularly when soldering.
Dip and hand soldering should not be done more than one time
After soldering the LEDs, the epoxy bulb should be protected from mechanical shock or
vibration until the LEDs return to room temperature.
A rapid-rate process is not recommended for cooling the LEDs down from the peak
temperature.
Although the recommended soldering conditions are specified in the above table, dip or
Everlight Electronics Co., Ltd.
Device Number : DLE-0000068
http:\\www.everlight.com
Prepared date:10-09-2008
Rev 1
Page: 8 of 10
Prepared : Flourix Chen