HIR89-01C-1R Datasheet, PDF (8/10 Pages) Everlight Electronics Co., Ltd – Infrared MIDLED LED

HIR89-01C/1R
4.Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350Ċ for 3
seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the damage of the product is often
started at the time of the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is
unavoidable, a double-head soldering iron should be used (as below figure). It should be
confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by
repairing.
Everlight Electronics Co., Ltd.
Device NojDIR-0000413
Revision : 1
LifecyclePhase:
http://www.everlight.com
Rev 1
Page: 8 of 10
Prepared datej12-10-2010
Prepared byjJAINE TSAI
Release Date:2010-12-16 13:53:02.0
Expired Period: Forever