ALS-PT19-315C-L177-TR8_15 Datasheet, PDF (8/11 Pages) Everlight Electronics Co., Ltd – Ambient Light Sensor

DATASHEET
Ambient Light Sensor
Surface - Mount
ALS-PT19-315C/L177/TR8
Recommended Solder Profile
Notice:
(1) Reflow soldering should not be done more than two times.
(2) When soldering, do not put stress on the devices during heating.
(3) After soldering, do not warp the circuit board.
Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350Ċ for 3 seconds within once in less than
the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be
careful because the damage of the product is often started at the time of the hand solder.
Repairing
Repair should not be done after the device have been soldered. When repairing is unavoidable, a double-head
soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the
device will or will not be damaged by repairing.
Revi8sion _Copy:_rig5_{ht © 2012, Everlight All Rights Reserved. Release Date : 12.24.2013. Issue No}R_{: D}e_Ll_Se_-a₀s₀₀e₀₀D₃₉ate_R:2_ev0_.514-02-1_w7_w1_w4_.:_e0_v8_e:_r5_li0_g._h0_t.com
LifecyclePhase:
Expired Period: Forever