40-01-T4C-4PRB Datasheet, PDF (8/8 Pages) Everlight Electronics Co., Ltd – Dome POWER LED

Technical Data Sheet
Dome POWER LED
40-01/T4C-4PRB
6. Soldering Condition
Careful attention should be paid during soldering. When soldering, leave more then 3mm
from solder joint to case, and soldering beyond the base of the tie bar is recommended.
Avoiding applying any stress to the lead frame while the LEDs are at high temperature
particularly when soldering.
Recommended soldering conditions:
Hand Soldering
DIP Soldering
Temp. at tip of iron
400℃ Max. (30W Max.)
Preheat temp.
100℃ Max. (60 sec Max.)
Soldering time
3 sec Max.
Bath temp.
265 Max.
Distance
3mm Min.(From solder joint Bath time.
5 sec Max.
to case)
Distance
3mm Min.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: [phone]
Fax: [phone]
http:\\www.everlight.com
Everlight Electronics Co., Ltd.
Device Number :DLE-400-001
http:\\www.everlight.com
Establish date: 07-11-2007
Rev. 1
Page: 8 of 8
Establish by: Jim Lin