English
Language : 

PIR67-21C Datasheet, PDF (7/10 Pages) Everlight Electronics Co., Ltd – Top View LED
PIR67-21C/L231/TR8
4.Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3
seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the damage of the product is often
started at the time of the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is
unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed
beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
Everlight Electronics Co., Ltd.
: Device No DTR-067-249
http:\\www.everlight.com
: Prepared date 06-08-2007
Rev 3
Page: 7 of 10
: Prepared by Daniel Yang