PD42-21C-TR8 Datasheet, PDF (7/10 Pages) Everlight Electronics Co., Ltd – 1.8mm Round Subminiature Silicin PIN Photodiode

PD42-21C/TR8
4.Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 280℃ for 3
seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the damage of the product is often
started at the time of the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is
unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed
beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
Everlight Electronics Co., Ltd.
Device No：DTD-042-042
http:\\www.everlight.com
Prepared date：04-25-2006
Rev 2
Page: 7 of 10
Prepared by：Jaine Tsai