30-01-G4C-ARTB-AM Datasheet, PDF (7/7 Pages) Everlight Electronics Co., Ltd – 3mm POWER LED

Technical Data Sheet
3mm POWER LED
30-01/G4C-ARTB
6. Soldering Condition
Careful attention should be paid during soldering. When soldering, leave more then 3mm
from solder joint to case, and soldering beyond the base of the tie bar is recommended.
Avoiding applying any stress to the lead frame while the LEDs are at high temperature
particularly when soldering.
Recommended soldering conditions:
Hand Soldering
Temp. at tip of iron
℃ 300 Max. (30W Max.)
Preheat temp.
DIP Soldering
℃ 100 Max. (60 sec Max.)
Soldering time
3 sec Max.
Bath temp.
260 Max.
Distance
3mm Min.(From solder joint Bath time.
5 sec Max.
to case)
Distance
3mm Min.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: [phone]
Fax: [phone]
http:\\www.everlight.com
Everlight Electronics Co., Ltd.
Device number: DLE-300-098
http:\\www.everlight.com
Established date: 11-23-2007
Rev.1
Page: 7 of 7
Established by: Eddie Huang