6374Y5DAAKMBXMS Datasheet, PDF (6/6 Pages) Everlight Electronics Co., Ltd – This precision optical performance oval LED is specifically designed for passenger information signs

Technical Data Sheet
6374/Y5DA-AKMB/X/MS
Notes
1. Above specification may be changed without notice. EVERLIGHT will reserve authority on
material change for above specification.
2. When using this product, please observe the absolute maximum ratings and the instructions for
using outlined in these specification sheets. EVERLIGHT assumes no responsibility for any
damage resulting from use of the product which does not comply with the absolute maximum
ratings and the instructions included in these specification sheets.
3. These specification sheets include materials protected under copyright of EVERLIGHT
corporation. Please don’t reproduce or cause anyone to reproduce them without EVERLIGHT’s
consent.
4. Soldering Condition
Careful attention should be paid during soldering. When soldering, leave more then 3mm
from solder joint to case, and soldering beyond the base of the tie bar is recommended.
Avoiding applying any stress to the lead frame while the LEDs are at high temperature
particularly when soldering.
Recommended soldering conditions:
Hand Soldering
DIP Soldering
400℃ Max. (30W
Temp. at tip of iron
Max.)
Preheat temp. 100℃ Max. (60 sec Max.)
Soldering time
3 sec Max.
Bath temp.
265 Max.
Distance
3mm Min.(From solder Bath time.
5 sec Max.
joint to case)
Distance
3mm Min.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: [phone]
Fax: [phone]
http:\\www.everlight.com
Everlight Electronics Co., Ltd.
Device Number : DLE-637-018
http\\:www.everlight.com
Prepared date:06-19-2006
Rev 1
Page: 6 of 6
Prepared by: Grace Shen