30-01USOC-S400-A9 Datasheet, PDF (6/6 Pages) Everlight Electronics Co., Ltd – Technical Data Sheet 3mm POWER LED

Technical Data Sheet
3mm POWER LED
30-01USOC/S400-A9
Notes
1. Above specification may be changed without notice. EVERLIGHT will reserve authority on
material change for above specification.
2. When using this product, please observe the absolute maximum ratings and the instructions
for using outlined in these specification sheets. EVERLIGHT assumes no responsibility for
any damage resulting from use of the product which does not comply with the absolute
maximum ratings and the instructions included in these specification sheets.
3. These specification sheets include materials protected under copyright of EVERLIGHT
corporation. Please don’t reproduce or cause anyone to reproduce them without EVERLIGHT’s
consent.
4. Soldering Condition
Careful attention should be paid during soldering. When soldering, leave more then 3mm from
solder joint to case, and soldering beyond the base of the tie bar is recommended.
Avoiding applying any stress to the lead frame while the LEDs are at high temperature
particularly when soldering.
Recommended soldering conditions
Hand Soldering
DIP Soldering
Temp. at tip of iron
400Ċ Max.
(30W Max.)
Preheat temp.
100Ċ Max.
(60 sec Max.)
Soldering time
3 sec Max.
Bath temp.
265 Max.
Distance
3mm Min.(From solder
joint to case)
Bath time.
5 sec Max.
Distance
3mm Min.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C.
Tel: [phone]
Fax: [phone]
http:\\www.everlight.com
Everlight Electronics Co., Ltd.
Device number: DLE-300-053
Revision : 3
LifecyclePhase:
http:\\www.everlight.com
Rev. 3
Page: 6 of 6
Established date: 08-20-2007
Established by: Jim Lin
Release Date:2008-09-20 00:15:51.0
Expired Period: Forever