IRM-26XXA Datasheet, PDF (4/10 Pages) Everlight Electronics Co., Ltd – Infrared Remote-control Receiver Module

EVERLIGHT ELECTRONICS CO.,LTD.
IRM-26xxA SERIES
Test Method：
The specified electro-optical characteristics is satisfied under the following
Conditions at the controllable distance.
cMeasurement place
A place that is nothing of extreme light reflected in the room.
dExternal light
Project the light of ordinary white fluorescent lamps which are not high
Frequency lamps and must be less then 10 Lux at the module surface.
(Ee≦10Lux)
eStandard transmitter
A transmitter whose output is so adjusted as to Vo=400mVp-p and the output
Wave form shown in Fig.-1.According to the measurement method shown in
Fig.-2 the standard transmitter is specified.
However , the infrared photodiode to be used for the transmitter should be
λp=940nm,∆λ=50nm. Also, photodiode is used of PD438B(Vr=5V).
fMeasuring system
According to the measuring system shown in Fig.-3
Fig.-1 Transmitter Wave Form
IR TANSMITTER
OUTPUT WAVE FORM
Carrier frequency is adjusted to
center frequency of each product.
D.U.T output Pulse
OUTPUT PULSE
OF DEVICE
Duty=0.5
Everlight Electronics Co., Ltd.
Device No：DMO-026-310
http:\\www.everlight.com
Prepared date：07-20-2005
Rev 2
Page: 4 of 10
Prepared by： Carryll Hsu