ALS-PDIC17-57B-TR8 Datasheet, PDF (16/19 Pages) Everlight Electronics Co., Ltd – Surface - Mount I2C Digital Ambient Light Sensor

Surface - Mount
I²C Digital Ambient Light Sensor
ALS-PDIC17-57B/TR8
Soldering Iron
℃ Each terminal is to go to the tip of soldering iron temperature less than 350 for 3
seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the damage of the product is
often started at the time of the hand solder.
Repairing
Repair should not be done after the device have been soldered. When repairing is
unavoidable, a double-head soldering iron should be used (as below figure). It should be
confirmed beforehand whether the characteristics of the device will or will not be damaged by
repairing.
Everlight Electronics Co., Ltd.
Document No: DLS-00000xx Rev0.1
16
http://www.everlight.com
Jun. 22, 2011