61-23-R6GHBHC-A01 Datasheet, PDF (12/12 Pages) Everlight Electronics Co., Ltd – Luminosity Full Color LED

EVERLIGHT ELECTRONICS CO., LTD.
Technical Data Sheet - Preliminary
Luminosity Full Color LED
61-23 /R6GHBHC-A01/ET
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within
once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time
of the hand solder.
5. Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand
whether the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: [phone]
Fax: [phone]
http://www.everlight.com
Everlight Electronics Co., Ltd
Device No.:
http://www.everlight.com
Prepared date: 20-Nov-2007
Rev. 1.1
Page: 12 of 12
Prepared by: Josh Chou