30-01-B4C-AKNB_09 Datasheet, PDF (12/12 Pages) Everlight Electronics Co., Ltd – 3mm Piranha

EVERLIGHT ELECTRONICS CO., LTD.
Technical Data Sheet
3mm Piranha
30-01-B4C-AKNB
ultrasonic cleaning on the LEDs depends on factors such as ultrasonic power and the
assembled condition. Ultrasonic cleaning shall be pre-qualified to ensure this will not
cause damage to the LED
6. Heat Management
Heat management of LEDs must be taken into consideration during the design stage of
LED application. The current should be de-rated appropriately by referring to the
de-rating curve found in each product specification.
The temperature surrounding the LED in the application should be controlled. Please refer
to the data sheet de-rating curve.
7. ESD (Electrostatic Discharge)
Electrostatic discharge (ESD) or surge current (EOS) can damage LEDs.
An ESD wrist strap, ESD shoe strap or antistatic gloves must be worn whenever handling
LEDs.
All devices, equipment and machinery must be properly grounded.
Use ion blower to neutralize the static charge which might have built up on surface of the
LEDs plastic lens as a result of friction between LEDs during storage and handing.
8. Other
Above specification may be changed without notice. EVERLIGHT will reserve authority
on material change for above specification.
When using this product, please observe the absolute maximum ratings and the
instructions for using outlined in these specification sheets. EVERLIGHT assumes no
responsibility for any damage resulting from use of the product which does not comply
with the absolute maximum ratings and the instructions included in these specification
sheets.
These specification sheets include materials protected under copyright of EVERLIGHT
corporation. Please don’t reproduce or cause anyone to reproduce them without
EVERLIGHT’s consent.
Everlight Electronics Co., Ltd.
Device No.: DLE-300-097
http://www.everlight.com
Published date: Nov.-24-2009
Rev.: 2.0
Created by: Ken Lee
Page: 12 of 12