95-21SUGC-S400-XX-XXX Datasheet, PDF (11/11 Pages) Everlight Electronics Co., Ltd – 1.9mm Round Subminiature Lead LEDs

95-21SUGC/S400-XX/XXX
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 280℃ for 3 seconds
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of
the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable,
a double-head soldering iron should be used (as below figure). It should be confirmed beforehand
whether the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: [phone]
Fax: [phone]
http://www.everlight.com
Everlight Electronics Co., Ltd.
Device No. : DSE-0001706
http://www.everlight.com
Prepared date: 08-Jun-2009
Rev. 2
Page: 11 of 11
Prepared by: Niu yanling