30-01-B84-YSC-A1T1U1DH-AM Datasheet, PDF (11/13 Pages) Everlight Electronics Co., Ltd – 3mm Power LED

EVERLIGHT ELECTRONICS CO., LTD.
Technical Data Sheet
3mm Power LED
30-01-B84-YSC-A1T1U1DH-AM
Notes
1. Lead Forming
During lead formation, the leads should be bent at a point at least 3mm from the base of
the epoxy bulb.
Lead forming should be done before soldering.
Avoid stressing the LED package during leads forming. The stress to the base may
damage the LED’s characteristics or it may break the LEDs.
Cut the LED leadframes at room temperature. Cutting the leadframes at high temperatures
may cause failure of the LEDs.
When mounting the LEDs onto a PCB, the PCB holes must be aligned exactly with the
lead position of the LED. If the LEDs are mounted with stress at the leads, it causes
deterioration of the epoxy resin and this will degrade the LEDs.
2. Storage
The LEDs should be stored at 30°C or less and 70%RH or less after being shipped from
Everlight and the storage life limits are 3 months. If the LEDs are stored for 3 months or
more, they can be stored for a year in a sealed container with a nitrogen atmosphere and
moisture absorbent material.
Please avoid rapid transitions in ambient temperature, especially, in high humidity
environments where condensation can occur.
3. Soldering
Careful attention should be paid during soldering. Solder the LED no lower than 1.6mm
from the base of stopper is recommended.
Avoiding applying any stress to the lead frame while the LEDs are at high temperature
particularly when soldering.
Recommended soldering conditions:
Hand Soldering
Temp. at tip of iron
℃ 300 Max. (30W Max.)
DIP Soldering
Preheat temp.
℃ 100 Max. (60 sec Max.)
Soldering time
3 sec Max.
Bath temp.
260 Max.
Distance
No lower than 1.6mm from Bath time.
5 sec Max.
the base of stopper
Distance
No lower than 1.6mm from
the base of stopper
Everlight Electronics Co., Ltd.
Device No.: DPE-0000133
http://www.everlight.com
Published date: Nov-17-2009
Rev.: 2
Created by: Eddie Huang
Page: 11 of 13