Y2C-AP2R2L Datasheet, PDF (10/10 Pages) Everlight Electronics Co., Ltd – Technical Data Sheet Top View LEDs

EVERLIGHT ELECTRONICS CO.,LTD.
Technical Data Sheet - Preliminary
Top View LEDs
67-21/Y2C-AP2R2L/2T
4.Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within
once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of
the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand
whether the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: [phone]
Fax: [phone]
http://www.everlight.com
Everlight Electronics Co., Ltd.
Device No. : DSE-671-615
http://www.everlight.com
Prepared date: 20-Nov-2007
Rev. 1
Page: 10 of 10
Prepared by: Ryan Chen