W1D-APQHY Datasheet, PDF (10/11 Pages) Everlight Electronics Co., Ltd – Chip LED (1.1mm Height)

EVERLIGHT ELECTRONICS CO.,LTD.
Precautions For Use
15-21/T1D-APQHY/2T
1. Over-current-proof
Customer must apply resistors for protection , otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package: The LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 After opening the package : The LEDs should be kept at 30℃ or less and 70%RH or less(Floor life).
However, it's recommended that the LEDs should be used within 168 hours (7 days) after opening
the package. If unused LEDs remain, it should be stored in moisture proof packages.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.
2.5 The LEDs should be used within 168 hours (7 days) after opening the package.
2.6 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60±5℃ for 24 hours.
3. Soldering Condition
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
Everlight Electronics Co., Ltd.
Device No:SZDSE-151-T01
http://www.everlight.com
Prepared date:09.08.2005
Rev 1
Page: 10 of 11
Prepared by: