ALS-PDIC17-77B-TR8 Datasheet, PDF (10/13 Pages) Everlight Electronics Co., Ltd – Ambient Light Sensor

Surface - Mount
Ambient Light Sensor
ALS-PDIC17-77B/TR8
Soldering Iron
℃ Each terminal is to go to the tip of soldering iron temperature less than 350 for 3
seconds within once in less than the soldering iron capacity 25W. Leave two seconds and
more intervals, and do soldering of each terminal. Be careful because the damage of the
product is often started at the time of the hand solder.
Repairing
Repair should not be done after the device have been soldered. When repairing is
unavoidable, a double-head soldering iron should be used (as below figure). It should be
confirmed beforehand whether the characteristics of the device will or will not be
damaged by repairing.
Everlight Electronics Co., Ltd.
Document No: DLS-0000020 Rev 1
10
http://www.everlight.com
Mar. 26, 2010