ALS-PDIC15-21C_10 Datasheet, PDF (10/13 Pages) Everlight Electronics Co., Ltd – Surface-Mount Ambient Light Sensor

Surface-Mount
Ambient Light Sensor
Soldering Iron
ALS-PDIC15-21C/L230/TR8
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within once
in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering
of each terminal. Be careful because the damage of the product is often started at the time of the hand
solder.
Repairing
Repair should not be done after the device have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand
whether the characteristics of the device will or will not be damaged by repairing.
Everlight Electronics Co., Ltd.
Document No: DLS-0000009 Rev 4
10
http://www.everlight.com
December 7, 2010