95-21SYGC-S530-XX-XXX Datasheet, PDF (10/11 Pages) Everlight Electronics Co., Ltd – 1.9mm Round Subminiature Lead LED

EVERLIGHT ELECTRONICS CO.,LTD.
95-21SYGC/S530-XX/XXX
Precautions For Use
1. Over-current-proof
Customer must apply resistors for protection , otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30Ċ or less and 90%RH or less.
2.3 After opening the package, the LEDs should be kept at 30Ċ or less and 60%RH or less.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60Ô5Ċ for 24 hours.
3. Soldering Condition
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
Everlight Electronics Co., Ltd.
Device No. : SZDLE-952-010
Revision : 2
LifecyclePhase:
http://www.everlight.com
Rev. 2
Page: 10 of 11
Prepared date: 14-Sep-2007
Prepared by:zhang hua
Release Date:2008-09-20 00:16:09.0
Expired Period: Forever