93-21SUBC Datasheet, PDF (10/10 Pages) Everlight Electronics Co., Ltd – High Performance SMD LED with Reflector

EVERLIGHT ELECTRONICS CO.,LTD.
93-21SUBC/S400-XX/TR8
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3
seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the damage of the product is often
started at the time of the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is
unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed
beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: [phone]
Fax: [phone]
http://www.everlight.com
Everlight Electronics Co., Ltd.
Device No. : DSE-931-070
http://www.everlight.com
Prepared date:23.Sep.2005
Rev. 2
Page: 10 of 10
Prepared by: Teresa Lee